Anisotropy of Mechanical Properties of 3D-Printed Materials—Influence of Application Time of Subsequent Layers

作者：Marcin Maroszek, Izabela Hager, Katarzyna Mróz, Mateusz Sitarz, Marek Hebda · 发表于：Materials · 年份：2025 · DOI：10.3390/ma18163845 · 被引用次数：23 · 研究领域：Innovations in Concrete and Construction Materials、Additive Manufacturing and 3D Printing Technologies、Bone Tissue Engineering Materials

Three-dimensional concrete printing (3DCP) is an emerging additive manufacturing technology with increasing application potential in the construction industry, offering advantages such as reduced labor requirements, shortened construction time, and material efficiency. However, structural integrity remains a challenge, particularly due to weak interlayer bonding resulting from the layered manufacturing process. This study investigates the mechanical performance and anisotropy of 3D-printed mineral-based composites with respect to the time interval between successive layers. Specimens were printed with varying interlayer intervals (0, 25, and 50 min) and tested in different loading directions. Flexural, compressive, and tensile strengths (direct and splitting methods) were measured both parallel and perpendicular to the layer orientation. Results showed a clear degradation in mechanical properties with increasing interlayer time, particularly in the direction perpendicular to the layers. Flexural strength decreased by over 25% and direct tensile strength by up to 40% with a 25 min interval. Compressive strength also declined, though less dramatically. Compared to cast specimens, printed elements showed 3-4 times lower compressive strength, highlighting the significant impact of interlayer cohesion. This study confirms that both the time between layers and the loading direction strongly influence mechanical behavior, underlining the anisotropic nature of 3DCP elements and the n...