Experimental and numerical simulation of dynamic fractionation for methane carbon isotope during shale gas depletion development

作者：Jun Wang, Shusheng Gao, Xianggang Duan, Wenbiao Li, Fangwen Chen, Ziyi Wang, Lingqi Liu, Pengfei Zhang, Guohui Chen, Nengwu Zhou, Guoshuai Bai, Shuangfang Lu · 发表于：Fuel · 年份：2025 · DOI：10.1016/j.fuel.2025.136354 · 被引用次数：4 · 研究领域：Hydrocarbon exploration and reservoir analysis、Methane Hydrates and Related Phenomena、Hydraulic Fracturing and Reservoir Analysis

Evaluating the adsorbed gas ratio (AGR) in the cumulative/daily production of shale gas is essential for optimizing development strategies, but no widely accepted method exists in the industry. The isotope fractionation method has emerged as a potential tool to achieve this goal. This study conducted isotope fractionation experiments on full-diameter shale under overburden pressure conditions during the shale gas depletion development. The results demonstrate that carbon and hydrogen isotopes during shale gas production exhibit a three-stage fractionation behavior, characterized by “stable (Ⅰ)–decreasing (Ⅱ)–increasing (Ⅲ)”. On this basis, an innovative carbon isotope fractionation model for 12 CH 4 and 13 CH 4 during mass transport in the dual-porosity medium was established, which effectively reduced the multi-solution of traditional numerical models by simultaneously matching the experimental data of production, pressure, and δ 13 C 1 value. Quantitative calculations indicate that in Stage I of the isotope fractionation, fracture gas is dominant. In Stage II, the produced gas is contributed by both fracture gas and matrix gas, with free gas dominating the matrix gas and adsorbed gas being secondary (the turning point of Stage II and Stage III (P 2 ) corresponds to an AGR of 48.30% in daily gas production), and a large amount of adsorbed gas still not effectively utilized (P 2 corresponds to an adsorbed gas recovery ratio of 18.84%). Starting from Stage III, adsorbed gas gr...