Nanoarchitectonics of High-Performance and Flexible n-Type Organic–Inorganic Composite Thermoelectric Fibers for Wearable Electronics

作者：Jiajia Li, Xinyang He, Junhui Wang, Suiyuan Zhu, Mingcheng Zhang, Changxuan Wu, Guoying Dong, Ruiheng Liu, Liming Wang, Lidong Chen, Kefeng Cai · 发表于：ACS Nano · 年份：2025 · DOI：10.1021/acsnano.5c01168 · 被引用次数：35 · 研究领域：Advanced Thermoelectric Materials and Devices、Thermal Radiation and Cooling Technologies、Thermal properties of materials

Since most conductive polymers are p -type, developing high-performance n -type organic–inorganic composite thermoelectric (TE) fibers is a great challenge. Herein, poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS)-coated Ag 2 Te nanowires (PC-Ag 2 Te NWs) were prepared by a liquid-phase reaction using PEDOT:PSS-coated Te nanowires (PC-Te NWs) as templates, and the PEDOT:PSS/PC-Ag 2 Te NWs composite fibers were then prepared by wet spinning. As the content of PC-Ag 2 Te NWs increases, the composite fiber changes from p -type to n -type. The PEDOT: PSS coating greatly improves the dispersibility of Ag 2 Te NWs in the PEDOT: PSS matrix, resulting in an ultrahigh content of 87.5 wt % of PC-Ag 2 Te NWs in the composite fibers, which exhibited a Seebeck coefficient of −61.3 μV K –1 and a power factor of 65.3 μW m –1 K –2 . The power factor value is higher than those of previously reported n -type composite TE fibers. Contrary to the estimated thermal conductivity in other reports, in this work, the thermal conductivity of the composite fibers was measured via a transient photoelectrothermal (TPET) technique. In addition, the composite fiber has good tensile properties and mechanical strength, elongating at a break of 47.37% and a tensile stress of 6.59 MPa. For an application demonstration, a self-powered temperature sensor was assembled, which can utilize the vertical temperature difference between the human body and the environment and respond quickly to a smal...