Impacts of Temperature and Surfactant on Wettability in Mineral–Oil–Water Systems

作者：Hua Tian, Ting Chen, Xiaohan Wang, Yajun Li, Bin Pan · 发表于：ACS Omega · 年份：2025 · DOI：10.1021/acsomega.4c06896 · 被引用次数：12 · 研究领域：Enhanced Oil Recovery Techniques、Hydrocarbon exploration and reservoir analysis、Hydraulic Fracturing and Reservoir Analysis

Mineral wettability is a crucial factor that determines the distribution of oil and water at the pore scale and, thus, influences oil reserves and recovery efficiency at the reservoir scale. Adding surfactants is one of the most common methods used to modify mineral wettability. However, previous studies on modifying mineral wettability via surfactants were mainly performed under room-temperature conditions, which do not represent the high-temperature reservoir conditions. A systematic investigation of the effects of temperature and surfactant on wettability in mineral-oil-water systems is still lacking. Therefore, in this study, the impact of temperature (25 °C vs 50 °C), surfactant type (cetyltrimethylammonium bromide [CTAB] vs sodium dodecyl sulfate [SDS]), and concentration (0-0.2 wt %) on the wettability of three representative minerals (including quartz, mica, and calcite) was systematically investigated via water contact angle (θ) measurements in an oil environment. It is demonstrated that as the temperature increased, in the presence of CTAB (0.024 wt %), quartz and mica became more oil-wet, while calcite became more water-wet. In the presence of SDS (0.2 wt %), quartz, mica, and calcite became more water-wet. At 50 °C, with the increased CTAB concentration, quartz, mica, and calcite became more oil-wet and then became more water-wet. At 50 °C, for quartz and mica, they become strongly oil-wet (quartz: 140°; mica: 163°) at the specified CTAB concentration (0.006 wt %)...