Photomultiplication-Type All-Polymer Photodetectors with a Signal-to-Noise Ratio over 118,800

作者：Haolan Zhang, Xingchao Zhao, R.H. Gong, Kaixuan Yang, Nayoung Kim, Xiaoling Ma, Lifang Lu, Han Young Woo, Fujun Zhang · 发表于：ACS Applied Electronic Materials · 年份：2024 · DOI：10.1021/acsaelm.4c01715 · 被引用次数：11 · 研究领域：Analytical Chemistry and Sensors、Organic Electronics and Photovoltaics、Nanowire Synthesis and Applications

Photomultiplication (PM) type all-polymer photodetectors (PM-APPDs) were fabricated by using polymer donor P3HT and polymer acceptor PY-IT as the photoactive layers. An optimal weight ratio of P3HT to PY-IT is approximately 100:4 to achieve an efficient hole transport channel and numerous isolated electron traps formed by P3HT/PY-IT/P3HT. These active layers exhibit hole-only transport characteristics, resulting in a low dark-current density ( J D ) of PM-APPDs. And J D of the PM-APPDs can be further suppressed by employing a triphenylamine-based cationic conjugated polyelectrolyte, TPAFA-7Br, as a hole transport layer (HTL) instead of a PEDOT:PSS layer. The optimal PM-APPDs with TPAFA-7Br as HTL display a rather low J D of 1.8 × 10 –9 A·cm –2 under −10 V bias, which is significantly lower than the 2.1 × 10 –6 A·cm –2 for PM-APPDs with PEDOT:PSS as HTL under the same bias. Additionally, the optimal PM-APPDs display an external quantum efficiency (EQE) of 1760% and a specific detectivity ( D * shot ) of 0.9 × 10 14 Jones at 630 nm under 0.6 mW·cm –2 white light illumination. The resulting linear dynamic range of the optimal PM-APPDs is 122 dB, exhibiting a significant improvement compared to 106 dB for PM-APPDs with PEDOT:PSS as HTL. The signal-to-noise ratio of the optimized PM-APPDs reaches 118,800 under −10 V bias and 0.6 mW·cm –2 white light illumination, which should be among the best values for organic photodetectors without an additional current amplifier.