Usability of Ultrasonic Frequency Testing for Rapid Generation of High and Very High Cycle Fatigue Data

作者：M. Fitzka, Bernd M. Schönbauer, Robert K. Rhein, Niloofar Sanaei, Shahab Zekriardehani, Srinivasan Arjun Tekalur, Jason W. Carroll, H. Mayer · 发表于：Materials · 年份：2021 · DOI：10.3390/ma14092245 · 被引用次数：44 · 研究领域：Fatigue and fracture mechanics、Ultrasonics and Acoustic Wave Propagation、Non-Destructive Testing Techniques

Ultrasonic fatigue testing is an increasingly used method to study the high cycle fatigue (HCF) and very high cycle fatigue (VHCF) properties of materials. Specimens are cycled at an ultrasonic frequency, which leads to a drastic reduction of testing times. This work focused on summarising the current understanding, based on literature data and original work, whether and how fatigue properties measured with ultrasonic and conventional equipment are comparable. Aluminium alloys are not strain-rate sensitive. A weaker influence of air humidity at ultrasonic frequencies may lead to prolonged lifetimes in some alloys, and tests in high humidity or distilled water can better approximate environmental conditions at low frequencies. High-strength steels are insensitive to the cycling frequency. Strain rate sensitivity of ferrite causes prolonged lifetimes in those steels that show crack initiation in the ferritic phase. Austenitic stainless steels are less prone to frequency effects. Fatigue properties of titanium alloys and nickel alloys are insensitive to testing frequency. Limited data for magnesium alloys and graphite suggest no frequency influence. Ultrasonic fatigue tests of a glass fibre-reinforced polymer delivered comparable lifetimes to servo-hydraulic tests, suggesting that high-frequency testing is, in principle, applicable to fibre-reinforced polymer composites. The use of equipment with closed-loop control of vibration amplitude and resonance frequency is strongly advi...