Parameter Modeling Analysis of a Cylindrical Ferrite Magnetic Shield to Reduce Magnetic Noise

作者：Danyue Ma, Jixi Lu, Xiujie Fang, Ke Yang, Kun Wang, Ning Zhang, Bangcheng Han, Ming Ding · 发表于：IEEE Transactions on Industrial Electronics · 年份：2021 · DOI：10.1109/tie.2021.3050351 · 被引用次数：98 · 研究领域：Atomic and Subatomic Physics Research、Advanced Frequency and Time Standards、Magnetic Field Sensors Techniques

Magnetic field shields are important for electronic equipment, ultrahigh-sensitivity sensors, and electrical instruments. For ultrahigh-sensitivity atomic sensors, in particular, ferrite shields with low intrinsic magnetic noise are widely used. In this article, the calculation methods of longitudinal and transverse magnetic noise, which are calculated by loss, are analyzed. The experimental results confirm the feasibility of the model. Using the loss separation method, it is proved that the loss of ferrite magnetic shielding is mainly hysteresis loss, which is below 100 Hz. To effectively reduce the magnetic noise, we analyze the effect of structure parameters on the longitudinal and transverse magnetic noise, and the optimized parameters are obtained. The results show that the longitudinal magnetic noise decreases with the increasing aspect ratio and stabilize eventually. When the aspect ratio exceeds 1, the transverse magnetic noise remains practically unchanged. When the external diameter is fixed, by optimizing the thickness of the magnetic shield, the optimal solution for the longitudinal and transverse magnetic noise is obtained.