Variables Associated With Lag Screw Sliding After Single-Screw Cephalomedullary Nail Fixation of Intertrochanteric Fractures

作者：Joshua A. Parry, Travis Sapp, Joshua R. Langford, Kenneth J. Koval, George J. Haidukewych · 发表于：Journal of Orthopaedic Trauma · 年份：2020 · DOI：10.1097/bot.0000000000001730 · 被引用次数：23 · 研究领域：Hip and Femur Fractures、Pharmacological Effects and Toxicity Studies、Bone fractures and treatments

OBJECTIVES: To evaluate variables associated with lag screw sliding after single-screw cephalomedullary nail (CMN) fixation of intertrochanteric femur fractures. DESIGN: Retrospective cohort study. SETTING: Level-one trauma center. PATIENTS/PARTICIPANTS: One hundred fifty-eight intertrochanteric fractures in patients older than 65 years with an average follow-up of 22 months. INTERVENTION: Single-screw CMN fixation. MAIN OUTCOME MEASUREMENTS: Lag screw sliding and revision surgeries. RESULTS: The average amount of lag screw sliding was 5 ± 5 mm (range, 0-21 mm). Lag screw sliding was greater with unstable fracture patterns (mean difference 2 mm, 95% confidence interval 0.4-3.5 mm, P = 0.01) and calcar gapping >4 mm (mean difference 3.7 mm, 95% confidence interval 2-5 mm, P < 0.01). No association was found between lag screw sliding and age, female gender, implants, long versus short nails, distal interlock screw use, postoperative neck-shaft angle, or tip-apex distance (P > 0.05). Revision surgeries were performed in 6 (4%) patients. Indications included symptomatic lag screw removal (n = 2), avascular necrosis (n = 1), cutout (n = 1), loss of reduction (n = 1), and perimplant fracture (n = 1). CONCLUSIONS: Unstable fracture patterns are unavoidable; however, careful attention to calcar reduction and selection of dual-screw CMN implants may minimize lag screw sliding and its detrimental effects on outcomes. LEVEL OF EVIDENCE: Prognostic Level III. See Instructions for Authors...