Low voltage Ohmic and electron cyclotron heating assisted startup in DIII-D

作者：B. Lloyd, G.L. Jackson, T. S. Taylor, E. A. Lazarus, T. C. Luce, R. Prater · 发表于：Nuclear Fusion · 年份：1991 · DOI：10.1088/0029-5515/31/11/001 · 被引用次数：224 · 研究领域：Magnetic confinement fusion research、Fusion materials and technologies、Superconducting Materials and Applications

There is considerable interest in the development of low voltage startup scenarios for large tokamaks since it is proposed that in ITER the electric field which will be applied for ionization and plasma current ramp-up will be limited to values of E ≤ 0.3 V/m. Studies of low voltage startup have been carried out in DIII-D with and without electron cyclotron preionization and preheating. Successful Ohmic startup has been achieved with E ∼ 0.25 V/m by paying careful attention to error fields and prefill pressure, while electron cyclotron heating (ECH) assisted startup with E ∼ 0.15 V/m has been demonstrated. ECH assisted startup gives improved reliability at such low electric fields and permits operation over an extended range of prefill pressures and error magnetic fields. Using ECH, startup at E = 0.3 V/m with |B ⊥ | > 50 G over most of the vessel cross-section has been demonstrated. Such an error field represents an increase by more than a factor of two over the highest value for which Ohmic startup was achieved at the same electric field. During low voltage Ohmic startup with extreme values of prefill pressure and/or error magnetic fields, excessive breakdown delays are observed. The experimental data agree well with theoretical predictions based on the Townsend avalanche theory. ECH assisted startup is always prompt. The primary effect of ECH during the plasma current ramp-up is a decrease of the resistive component of the loop voltage V rcs . A significant reduction (∼30%...